- 686 - sb101 thru sb107 single phase 10 amps. silicon bridge rectifiers voltage range 50 to 1000 volts current 10.0 amperes f eatures ul recognized file # e-96005 surge overload rating 200 amperes peak low forward voltage drop high temperature soldering guaranteed: 260 / 10 seconds / 0.375? ( 9.5mm ) lead length at 5 lbs., ( 2.3 kg ) tension small size, simple installation leads solderable per mil-std-202 method 208 sb-10 dimensions in inches and (millimeters) m aximum ratings and electrical characteristics rating at 25 ambient temperature unless otherwise specified. single phase, half wave, 60 hz, resistive or inductive load. for capacitive load, derate current by 20% type number symbol sb 101 sb 102 sb 103 sb 104 sb 105 sb 106 sb 107 unit s maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 v maximum rms voltage v rms 35 70 140 280 420 560 700 v maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 v maximum average forward rectified current @t a = 50 i (av) 10 a peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (jedec method ) i fsm 300 a maximum instantaneous forward voltage @ 5.0a v f 1.1 v maximum dc reverse current @ t a =25 at rated dc blocking voltage @ t a =100 i r 10 500 ua ua typical thermal resistance (note) r jc 5 /w operating temperature range t j -55 to +125 storage temperature range t stg -55 to +150 note: thermal resistance from junction to case per leg.
fig.1- maximum non-repetitive forward surge current per bridge element peak for ward surge current . (a) 10 2 5 1 50 20 100 150 50 100 200 250 300 number of cycles at 60hz 8.3ms single half sine wave jedec method tj=25 c 0 0 - 687 - ratings and characteristic curves (sb101 thru sb107) fig.4- typical reverse characteristics per bridge element 0 20 40 60 80 100 120 140 0.01 0.1 1 10 percent of rated peak reverse voltage. (%) tj=100 c 0 tj=25 c 0 fig.2- maximum forward current derating curve average for ward current . (a) 0 50 100 150 0 10 2 4 6 8 ambient temperature. ( c) o fig.3- typical instantaneous forward characteristics per bridge element instantaneous for ward current . (a) 0.6 0.8 1.0 1.2 1.4 1.6 2.0 1.8 0.1 0.01 1 10 100 instantaneous forward voltage. (v) tj=25 c pulse width-300 s 1% duty cycle 0 instantaneous reverse current .( a)
|
